Skip to main content

Full text of "Nikon Coolpix 3500 Repair Manual"

See other formats


Installing Nikon Coolpix 3500 Lens 




Installing Nikon Coolpix 3500 Lens 




step 1 - Battery 

• Open the battery cover 

• Remove the battery 

• Gently remove the cover 




Step 2 - front cover 

• Remove two 4.5 mm screws next to the battery opening 
Remove one 3 mm screw above the CF Card opening 

• Remove one 4.5 mm screw next to CF card opening 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 1 of 5 



Installing Nikon Coolpix 3500 Lens 




Step 3 

• Remove two 4.5 mm screws from inside the battery slot 




Step 4 

• Remove two 5 mm screws from the end opposite to the 
battery 




Steps 

• Remove the newly revealed 5 mm screw and plastic cap 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 2 of 5 



Installing Nikon Coolpix 3500 Lens 




Step 6 

• Remove the five identical 3.5 mm screws from the 
bottom of the camera 

• Remove the grey plastic piece that was held in place 
with the five screws by gently prying the faceplate up 
(Note: do not pull hard, there are two wires connecting 
the faceplate to the logic board) 




Step? 

• Use the spudger to lift up the white-capped wire and set 
the faceplate aside 

• Next, use a spudger, lift up the orange-capped wire at 
the bottom of the camera 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 3 of 5 



Installing Nikon Coolpix 3500 Lens 




Step 8 - Lens 

• Disconnect the grey-capped wire from the logic board 

Disconnect the blue wire attached to the green chip 
from the center of the logic board 




Step 9 

• Remove the 3.5 mm screw from the logic board next to 
the rotating lens 

• Invert the logic board and lens toward the orange and 
blue wires still connecting the logic board to the LED 
screen 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 4 of 5 



Installing Nikon Coolpix 3500 Lens 




Step 10 

• Disconnect the blue wire connecting the logic board to 
the LED screen 

Disconnect the orange wire using a spudger while 
pushing out horizontally 

• Disconnect the red capped wire from the logic board 

• Lift the logic board and lens (still connected) out of the 
back case 







kii' 


1 

A 


rV 


4 


^-^'■'^^A Z^^^^^BH 


\d^k s 




^^ 




i^ ^ 


1^-" 




1 ^ 


/^^^^^H 


%^ 


W^ 


-«> 




1 


% 






' ^ 


PjI^^P^^^x^^J^I 




xjH^^ 


g 







step 11 

• Lift up on the black covering and remove the orange 
wire connecting the lens to the logic board 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 5 of 5